The Central Electricity Authority (CEA) and the Danish Energy Agency (DEA) have released the Indian Technology Catalogue for Energy Storage 2026, the first edition of a catalogue that gives planners a common set of technical and cost data for storage technologies. The 161-page document appeared on the CEA website on 11 November 2026 under “What’s New”. It was prepared under the India-Denmark Energy Partnership, and a companion Technology Catalogue for Green Fuels was released in parallel.
Why the Technology Catalogue for Energy Storage matters
According to its preface, the main aim of a technology catalogue is to give energy planners a uniform, commonly accepted and up-to-date basis for their work. This includes future outlooks, evaluations of security of supply, environmental impact and climate studies, and technical and economic analyses. Only selected, representative technologies are included, so that similar options can be compared in a generic way.
CEA says the catalogue may be updated as technologies evolve or data change, with changes listed in an amendment sheet and the latest version always available on the CEA website. In 2022, CEA published a Technology Catalogue for the Generation and Storage of Electricity. The new document should be cited as “CEA & DEA, 2026, Indian Technology Catalogue for Energy Storage 2026”.
Nine storage technologies in the catalogue
After an introduction to power storage and a guideline chapter, the catalogue has chapters on lithium-ion batteries for grid-scale storage, sodium-ion batteries, pumped storage projects, vanadium redox flow batteries, compressed air energy storage, molten salt thermal storage, liquid air energy storage and compressed CO2 energy storage. An appendix explains the cost-projection method.
The introduction compares the technologies as of 2026 (Table 0-1 of the catalogue):
- Pumped hydro: full technical range of 100 to 3,600 MW, typical projects of 200 to 2,000 MW, discharge of 4 to 20 hours, commercial and mature
- Compressed air energy storage: 50 to 400 MW, typical 100 to 290 MW, 2 to 20 hours, commercial and growing
- Flow batteries: 1 kW to 200 MW, typical 0.5 to 30 MW, 2 to 20 hours, commercial and growing
- Lithium-ion (LFP and NMC): 1 kW to 4,000 MW, typical 1 to 1,000 MW, 15 minutes to 8 hours, commercial and mature
Lithium-ion and sodium-ion batteries
The lithium-ion chapter compares the two main grid chemistries. NMC cells (nickel manganese cobalt) have high energy density but use cobalt, while LFP (lithium iron phosphate) cells do not use cobalt in the cathode. The catalogue says LFP cells are not as widely used as NMC and are therefore generally higher priced, mainly because of lower production volumes, and that they have a lower global warming potential, by up to 50% according to a study it cites.
Two Indian examples are included. One is a 10 MW / 10 MWh NMC battery system in Delhi for Tata Power Delhi Distribution Limited, built by AES India with Mitsubishi Corporation and operating since April 2019. The other is a 20 MW / 40 MWh standalone system at BSES Rajdhani Power Limited’s Kilokari substation in New Delhi, supported by the Global Energy Alliance for People and Planet and executed with IndiGrid and AmpereHour Energy within a 20-month implementation period.
On sodium-ion, the catalogue gives a technology readiness level of 7 and says sodium-ion batteries are going through a critical period of commercialisation. It notes lower raw material costs and a better safety profile, but also lower energy density and a shorter cycle life than lithium-ion. The only large-scale project it describes is a 100 MW / 200 MWh station in Hubei province, China, of which half the capacity is online.
Pumped storage in the catalogue
The pumped storage chapter says the technology accounts for more than 90 per cent of grid-scale energy storage worldwide, with over 189 GW installed at the end of 2024. It covers on-stream, off-stream open-loop and off-stream closed-loop projects. Its list of Indian examples includes Tehri in Uttarakhand (1,000 MW, on-stream, THDC, 2025), Srisailam in Telangana (900 MW, on-stream, 2021), Purulia in West Bengal (900 MW, off-stream open-loop, 2007) and Pinnapuram in Andhra Pradesh (1,680 MW, off-stream closed-loop, Greenko, 2025). No significant cost reduction is expected, as the technology is mature.
How costs are projected
For lithium-ion, the cost projections use a learning-rate approach. The catalogue applies a 17% learning rate to the energy component of capital cost and 10% to the capacity component, other project costs, and fixed and variable operating costs. Global installed lithium-ion capacity is taken as 156 GW in 2024. Cumulative deployment in 2030, 2040 and 2050 is assumed at 853, 2,339 and 3,438 GW in the high-cost case, 1,015, 2,939 and 4,386 GW in the reference case, and 1,260, 3,802 and 5,512 GW in the low-cost case.
What it means for India’s clean-energy sector
As solar and wind capacity grows, storage planning needs consistent assumptions on cost, duration and maturity. A single government-backed reference helps utilities, regulators, developers and researchers compare lithium-ion, sodium-ion, pumped storage and long-duration options on the same basis.
Official references
- Central Electricity Authority, “Indian Technology Catalogue – Energy Storage, 2026” (What’s New): https://cea.nic.in/
- CEA and DEA, Indian Technology Catalogue for Energy Storage 2026 (PDF, 161 pages): https://cea.nic.in/whats-new/file?path=%2Fhome%2Fcea_website%2Freports%2Fgeneral%2Fhi%2FRE%20Work_India_TC_Energy-Storage_2026_APPROVED_1794324944314.pdf&mode=view

Leave a Comment